Test these commands

If the device responds correctly you have found a usable code set.

 

Make sure the device is off, then click the button to test.

POWER ON

VOLUME MUTE

Select a command from the list and press the Test button below to test the code. If the device responds correctly you have found a usable code set.

 

Aim the lens on the front of the base station directly at the device. Commands are sent from the front panel and rear ports of the base station.

Commands are sent through the controller with the following MAC: {{device.testBstationMac | macAddress}}

Enter the IP address and port used to control the device you are testing.

An IP address is required.

Please enter a valid IP address.

A port number is required.

Please enter a number between 0 and 65535.